I
A Safety Information
A1 First Aid
In Case of Electric Shock: Separate the person as quickly as possible from the electric power source:
• By switching the equipment off,
• By unplugging or disconnecting the mains cable, or
• By pushing the person away from the power source, using dry insulating
material (such as wood or plastic).
• After having suffered an electric shock, always consult a doctor.
Warning! Do not touch the person or his clothing before the power is turned off,
otherwise you stand the risk of suffering an electric shock as well!
If the Person is Unconscious: • Lay the person down
• Turn him to one side
• Check the pulse
• Reanimate the person if respiration is poor
• Call for a doctor immed iately.
Safety Information
To reduce the risk of electric shock, do not remove covers. No user-ser-
viceable parts inside. Refer servicing to qualified service personnel (i.e.,
persons having appropriate technical training and experience necessary
to be aware of hazards to which they are exposed in performing a repair
action, and of measures to minimize the danger of themselves).
This symbol alerts the user to the presence of un-insulated dangerous volt-
age within the equipment that may be of sufficient magnitude to constitute
a risk of electric shock to a person.
This symbol alerts the user to important instructions for operating and
maintenance in this documentation.
Assemblies or sub-assemblies of this product can contain opto-elec-
tronic devices. As long as these devices comply with Class I of laser or
LED products according to EN 60825-1:1994, they will not be expressly
marked on the product. If a special design should be covered by a higher
class of this standard, the device concerned will be marked directly on the
assembly or sub-assembly in accordance with the above standard.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ACHTUNG
GEFAHR: ELEKTRISCHER SCHLAG
NICHT ÖFFNEN
ATTENTION
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
CLASS 1
LASER PRODUCT
CLASS 1
LED PRODUCT
To Next Page
Loading...
Need help?
General
