OnAir 2500/OnAir 3000 Digital Mixing Consoles
Conguration 6-27
Date printed: 22.07.08
SW V3.0
6.5.15 System Time
On this page, all settings for operation with the internal real-time clock or an
external time reference signal are made.
Time Sync Ref The type of external time reference signal can be selected here from: None,
MONITORA (time information according to the Monitora protocol, e.g. from
a Studer DigiMedia CAB system), Ext.Time Sync*, or NTP (if the console
has access to an internet time server over a network). If None is selected, the
console operates on its own, internal real-time clock.
* The Ext. Time Sync button is displayed only if an optional time sync card
is installed that is connected to a time receiver; selection of the input signal
format is performed with DIP switches on the card (refer to OnAir 3000 ser-
vice instructions, chapter 3).
OnAir 2500: The Time Sync card is supported by OnAir 3000 only.
NTP Time Server If NTP has been selected above, the NTP time server’s web address is set
here. When touching this button, a keyboard appears for entering the address.
Proceed according to the corresponding paragraph in chapter 6.5.1.
Time Zone Enter your local time zone here. In the example above, the “(GMT +01:00)
Amsterdam/Berlin/Bern/Rome/Stockholm/Vienna” time zone is selected.
Automatic Daylight Saving Automatic daylight saving time for the internal watch is be activated here,
according to the selected time zone; this is regardless of the current external
time sync reference.
To Next Page
Loading...
Need help?
General
