5.3.8.2 (Admin) Fader Cal Page
First, select one of the fader modules to be calibrated by touching the cor-
responding button. The screen then changes as follows:
0 dB Position Always required; please note that it is recommended to perform this calibra-
tion for all faders of a fader module at a time.
First, move all faders not to be calibrated to their –20 dB position (this posi-
tion will be ignored during calibration).
Then move the fader(s) to be calibrated to their 0 dB positions.
Touch the 0 dB button.
To Next Page
Loading...
