Xerox 8825 - Page 104

01/02
4-36
8825/8830 Printer
REP 8.12
Repairs and Adjustments
Replacement
1. Reinstall the rolls and retainers onto the shaft.
2. (Figure 3): Reinstall the Registration Pinch Roll Assembly.
Figure 3 Reinstalling the Registration Pinch Roll Assembly
3. (Figure 4): Reinstall the springs.
4. Complete the reassembly of the Printer and perform the following:
a. Fuser Temperature (NVM) (ADJ 10.1)
b. Vertical Magnification (ADJ 8.1)
c. Lead Edge Registration (ADJ 8.2)
d. Cut Length (ADJ 8.3)
4
Bend the spring ends and
reinstall the springs into the
slots on the frame
Slot
3
Reinstall the Registration Pinch
Roll Assemblies
2
Reinstall the two
bearings (one each
end)
1
Reinstall the two E-
rings (one each)