Xerox 8825 - Page 163

01/02
4-95
8825/8830 Printer
REP 10.9
Repairs and Adjustments
3. (Figure 2): Remove the Takeup Roll.
Figure 2 Removing the Takeup Roll
Replacement
1. (Figure 3): Reinstall the Supply Roll.
Figure 3 Reinstalling the Takeup Roll
4
Pull the Stub Shaft/
Gear Assembly from
the Takeup Roll
1
Disengage the spring
from the stop on the
Side Plate
2
Pull the Stub Shaft /
Gear Assembly from
the LH Side Plate
LH Side Plate
3
Pull the Takeup Roll
off the RH Side Plate
(far side)
Spring Stop
1
Mount the opposite
end of the Supply
Roll onto the LH Side
Plate
2
Pull the knob and lock on
the Supply Roll
RH Side Plate
Supply Roll