ASTRO VG-871 - Page 20

6
“69”
The blanking period of the vertical timing data is outside the specified range.
“70”
The vertical frequency of the vertical timing data is outside the specified range.
“71”
VDstart + VDline of the vertical timing data are outside the specified range. (Vtotal ≥
VDstart + VDline)
“72”
EQPfp of the vertical timing data is outside the specified range.
“73”
EQPbp of the vertical timing data is outside the specified range.
“74”
An error other than the ones above occurred in the vertical timing data.
“75”
A timeout occurred in DDC1.
“76”
An ACK error occurred in DDC1.
“78”
An ACK error occurred in DDC2.
“80”
An error occurred in Macrovision.
“81”
An error occurred in a simple moving image.
“82”
There is an error in the header information of the EDID data.
“83”
Check sum error in the EDID data.
“84”
There is an error in the header information and check sum of the EDID data.
“85”
There is an error in the YPbPr coefficients.
“86”
There is an error in the audio data number.
“87”
Trouble in FAT for the audio data
“88”
Unregistered audio data
“90”
The wrong EDID port is used for lip sync.
“91”
The delay time for lip sync was set longer than the ON (or OFF) time.
“92”
Invalid EDID latency for lip sync.
“93”
A setting other than Inter-PCM/DCD has been selected for Audio Source for lip sync
or it is set to Sweep.
Fig. 1-7