Chapter 4 INDIVIDUAL FORMATS FOR CONTROL COMMANDS
3.7 CHACIRCPA4 [28H 26H]: Character plane filled-in
circle drawing
Function: This command draws a filled-in circle on the character plane.
Sequence: Type 2
Command:
Sign code + “0” to “4095”
Sign code: “0” = +, “1” = -
* -2048 (“12048”) to +4096 (“04095”) in
numerical terms
Sign code + “0” to “4095”
Sign code: “0” = +, “1” = -
* -2048 (“12048”) to +4096 (“04095”) in
numerical terms
Fig. 3-7-1
When the drawing mode setting is omitted as below, the dot is drawn in the Set mode.
Fig. 3-7-2
To Next Page
