3.10 CHATRI4 [28H 29H]: Character plane triangle
drawing
Function: This command draws a triangle on the character plane.
Sequence: Type 2
Command:
Sign code + “0” to “4095”
Sign code: “0” = +, “1” = -
* -2048 (“12048”) to +4096 (“04095”) in numerical
terms
Sign code + “0” to “4095”
Sign code: “0” = +, “1” = -
* -2048 (“12048”) to +4096 (“04095”) in numerical
terms
Fig. 3-10-1
When the drawing mode setting is omitted as below, the dot is drawn in the Set mode.
Fig. 3-10-2
To Next Page
Loading...
