Ateis IDA8S User Manual

IDA8 Global-Net User Manual256
© 2020, ATEÏS. All rights reserved.
Event Settings
After creating a Step Trigger event, users
need to assign an element to it.
1. Right click the desired element, and click
the options [Event > Step Trigger > XXX]
which XXX is the name of the event. See
the picture on the right.
2. Then there will be a window which
displays the event information
corresponded to trigger step. Tick the
checkbox on [Select] grid.
3. Click [Content...] button on Event Manager window to open the settings window of event.
State: Click [State] page tab to switch the state of value trigger event.
Element: The element of the component controlled by value trigger.
Component: The component of device contains the previously element.
Device/System: The device/system contains the previously component.
Step Value: The step value of the state.
Modify: Enable/disable the selected element controlled by the state of event.
Remove: Remove the element controlled by the event.
This action only removes the relation between the element and event and does not delete the
element.

Ateis IDA8S Specifications

General

Brand	Ateis
Model	IDA8S
Category	Security System
Language	English