Control Window
I/O Pins:
o Audio Input/Output: Select the
number of input/out pin you want.
o Logic Input/Output: Select the
number of logic input/output pin you
want.
Properties:
o Name: The name of the Initial
Component.
o Auto: Click or unclick the Auto
button if users want to change the
name of Initial Component.
Password:
o Enable Password: Click to enable the password
function. And enter the password and the
confirmation password again. If the password
function is enable, there will be a pop-up window
as the picture below,
Export:
The Export function allows users to save and export
the configuration on the Initial Component to the list
of Custom Component list.
Right click on the component and click [Export]
function. After the configuration has been exported,
the configuration will be listed on the list of Custom
Component. See the picture below,
To Next Page
Loading...
Need help?
General
