EasyManuals Logo

Barco FLM series User Manual

Barco FLM series
331 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
3. Troubleshooting
TB
TG
TR
E
H
R G B
BL
FR
Image 3-11
Sockets on the Formatter Interface Board (FIB) of the FLM HD series
R Temperature sense Red channel.
G Temperature sense Green channel.
B Temperature sense Blue channel.
BL Temperature sense DMD water cooling blocks.
FR Temperature sense DMD front.
E Temperature sense light processor air (Engine).
H Temperature sense Heat pipes cooling block.
TB Power supply for TEC front blue.
TG Power supply for TEC front green.
TR Power supply for TEC front red.
Error 7659 : “Engine air temp open”
This error may be preceded by a warning. This error can only appear on the FLM HD series.
Situation Solution
Wire unit of the temperature sensor
(ref E image 3-10) is disconnected
from the Formatter Interface Board.
Plug the wire unit of the temperature sensor (E) into its socket on the Formatter
Interface Board. See image 3-11.
Damaged wire unit of the
temperature sensor (ref E
image 3-10) causing an open
circuit.
Repair the wire unit.
If not repairable, replace the hole wire unit and temperature sensor.
Defect temperature sensor (ref E
image 3-10) of the light processor.
Replace the temperature sensor.
Error 7660 : “Engine air temp high”
This error may be preceded by a warning. This error can only appear on the FLM HD series.
Situation Solution
Air temperature inside the
compartment of the light processor
is to high.
Check if the air inlet at the front and at the bottom of the projector are free.
Check if the bottom filter of the projector is not filthy. Replace with new filter
if necessary.
Check if the front filter of the projector is not filthy. Replace with new filter if
necessary.
Check if the air outlet at the rear of the projector is not covered. There should be at
least one meter of free area at the rear of the projector.
Make sure that the plate, on which the projector is mounted for transport, is
removed.
Error 7662 : “Blue block temp short”
This error may be preceded by a warning. This error can only appear on the FLM HD series.
30
R59770072 FLM SERIES 19/03/2007

Table of Contents

Other manuals for Barco FLM series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Barco FLM series and is the answer not in the manual?

Barco FLM series Specifications

General IconGeneral
BrandBarco
ModelFLM series
CategoryProjector
LanguageEnglish

Related product manuals