892-0000010B OM
113
Adjust the parking brake control as follows:
- set parking brake control lever 8 to the forward position (away from you);
- loosen the locknut of adjusting bolt 1, as well as locknut 7 and remove pin 5;
- turn lever 4 and align the upper edge of the groove "B
2
" of lever 3 with the upper
edge of groove "B
1
" of lever 2 of the right brake pedal, and then, turning yoke 6, align the
holes of lever 4 and yoke 6 and insert pin 5;
- screw bolt 1 in or out so that, as you move the control lever towards yourself with a
force of 200
+10
N, the latch is held in the notch of the third or fourth teeth of sector “A”. After
adjustment, tighten the loose locknuts.
Perform the final check and adjustment of the parking brake on the assembled tractor.
The tractor must be kept on a slope of at least 18% when applying a force of no more than
400 N to parking brake control lever 8. If necessary, correct the adjustment using adjusting
bolt 1.
1 – adjusting bolt; 2 – lever of the right brake pedal; 3,4 – lever; 5 – pin; 6 – yoke; 7 –
locknut; 8 – parking brake control lever.
Figure 3.7.6 – Parking brake control lever
To Next Page
Loading...
