Belarus 892 - Side Semi-Continuous Power Take-Off Control

892-0000010B OM
43
2.14.2.3 Switch of two-speed continuous drive of rear PTO
The shifter arm of PTO continuous drive 2 (Figure 2.14.2) has two positions:
I - 540 min
-1)
- full shift position, clockwise;
II - 1000 min
-1)
- full shift position, counterclockwise.
In order to select the required PTO shaft rotation speed release bolt 1 by one revolu-
tion, turn arm 2 into position “I” and “II “ and tighten bolt 1.
ATTENTION: SHIFTING BETWEEN PTO SPEEDS SHALL BE CARRIED OUT
ONLY WHEN THE ENGINE IS NOT RUNNING!
Figure 2.14.2 – Shifting between PTO rotation speeds (transmission bottom view)
2.14.2.4 Tractor operation without use of rear PTO
When tractor is operated without the use of the rear PTO, the shifter arm of the continu-
ous two-speed PTO drive must be set into position 540 min
-1)
, the handle for shifting the rear
PTO from continuous to ground-speed drive - must be set into “neutral” position, the rear PTO
engagement lever – must be set into position “PTO off”. Protective cap of the rear PTO shaft
guard must be mounted.
2.14.3 Side semi-continuous power take-off control
The side semi-continuous power take-off shaft is controlled by a rod (Figure 2.14.3),
which is located on the left side of the operator's seat.
The rod has two fixed positions:
- "PTO on" – upper position;
- "PTO off" – lower position.
Figure 2.14.3 – Side power takeoff control