Belarus 892 - Tractor Stop; Engine Stop; Leaving the Tractor

892-0000010B OM
177
4.2.4 Tractor stop
To stop the tractor do the following:
- decrease engine speed;
- fully press the clutch pedal;
- set the range and gears shifting lever in neutral position;
- release the clutch pedal;
- stop the tractor by means of service brakes;
- engage the parking brake.
ATTENTION: FOR TRACTOR EMERGENCY STOP SHARPLY PRESS THE
CLUTCH AND BREAK PEDALS TOGETHER!
4.2.5 Engine stop
ATTENTION: BEFORE STOPPING THE ENGINE, MOVE DOWN THE LIFT LINK-
AGES UNTIL THEY REACH GROUND, IF THEY ARE UPLIFTED; LET THE ENGINE RUN
AT (1000±100) RPM FOR 3 TO 5 MINUTES. THIS WILL ALLOW TO REDUCE ENGINE
COOLANT TEMPERATURE!
To stop the engine, do the following:
- set the rear PTO control lever into “Disengaged” position, and set the handle to
switch rear PTO from ground-speed to continuous mode (if ground-speed mode is engaged)
into neutral;
- set the rod of side semi-continuous PTO control into position “disengaged”;
- lower implement to the ground;
- shift the control handles for the hydraulic lift linkage distributor into neutral position;
- turn off the heater fan;
- pull the engine stop handle;
- if continuous mode of rear PTO is engaged, set the handle of rear PTO switching
from continuous to ground-speed drive into “neutral” position;
- if the engine is stopped for a long time, deactivate the accumulator battery.
ATTENTION: FOR EMERGENCY ENGINE STOP, PULL THE ENGINE STOP HAN-
DLE!
4.2.6 Leaving the tractor
Leaving the tractor is carried out through the cab left door, except for emergency
situations. Rules on leaving the tractor at emergency situations are given in clause 4.5.3 of
subsection 4.5 “Emergency actions”.
Leaving the tractor, make sure that all actions, listed in subsection 3.2.5 “Engine stop”
have been performed, lift linkages of the tractor and of coupled implements have been low-
ered.