Belarus 892 - Possibility of Front Loader Installation; General Information

892-0000010B OM
218
5.10 Possibility of front loader installation
5.10.1 General information
When choosing, buying and mounting of mounted front loaders (hereinafter referred to as
loaders) pay attention to conditions specified in the present tractor operation manual and in
Table 5.10.1.
Table 5.10.1 – Rules of BELARUS-892/892.2 tractor use with loader
Name of indicator (characteristics) Indicator (characteristics) value
Standard size of tractor wheel tires to which
installation of loader is possible
BELARUS 892: 13.6-20
–
fron
t
, 16.9R38
–
rea
r
.
BELARUS 892.2: 360/70R24 – front, 18,4R34(F-11)
– rear (of basic configuration or imported tires of
the same t
y
pe
)
Tractor wheel tire pressure Inner pressure in wheel tires shall be settled as
for the speed of 30 km/h
Tractor wheel track, m, not less :
- for front wheels
- for front wheels
1800
2100
Tractor axle weight limit (with regard to trac-
tor and loader weights), kN, not more than:
- for front axle;
- for rear axle
24,0 (BELARUS 892),
37,0
(
BELARUS 892.2
)
50,0
Tractor weight with mounted loader, kg, not
more than 7000
Push force in cutting mode, kN, not more
than 18,0
overloadin
g
protection while in cuttin
g
mode
A
utomated protection in loader desi
g
n
Speed of tractor movement with loader in-
stalled, km/h, not more than:
- operation speed with load
- operation speed without load
- traveling speed
6
12
20
Tractor ballasting with loader installed (when
necessar
y)
1. Ballast weight
–
on rear lift linkage.
2. Water solution in rear tires
Places of loaders fastenin
g
to a tractor:
- loader mounting frame
Front beam, frame rail, clutch case
- loader push rods Semi-axle tubes, GB casin
g
s and rear axle
Shift-time control
(testing parameters, in addition to STMS op-
erations, listed in tractor and loader operation
manual
)
1. Tightness of fasteners of loader mounting
frame and tractor wheels.
2. Tractor tire pressure
Connection of loader h
y
draulic s
y
stem Tractor h
y
draulic outputs
Recommended adjustment pressure of safety
valve (when the automatic hydraulic distribu-
tion valve in a loader set is available) of the
loader hydraulic system, MPa, not more than
17,0
ATTENTION: FORK LOAD DEPENDS ON OVERHANG AND DESIGN OF LOADER
WORKING ATTACHMENTS, AND SPECIFICATIONS OF LIFTED LOAD!
IT IS FORBIDDEN TO USE WITH LOADER A TRACTOR HAVING NO CAB OR
CANOPY TENT, NO NOT-WILLED MOVEMENT LIMITING SYSTEM (SEAT BELT), AND
ALSO IN CONFIGURATION WITH FRONT AND REAR TIRES OF IRREGULAR CONFIG-
URATION.