892-0000010B OM
118
3.9 Tractor undercarriage
The BELARUS-892/892.2 tractors are made according to the wheel arrangement 4K4
and are equipped with low-pressure pneumatic tires.
The following tires are installed on the BELARUS-892 tractor in the basic configuration:
- 13.6-20 - front tires;
- 16.9R38 - rear tires;
By order of the customer, the following tires may be installed:
- 11.2-20 – front tires, in a set with rear tires 15.5R38, 18.4R34(F-11), 11.2R42, 9.5-
42;
The following tires are installed on the BELARUS-892.2 tractor in the basic configura-
tion:
- 360/70R24 - front tires;
- 18.4R34 (F-11) - rear tires;
By order of the customer, the following tires may be installed:
- 360/70R24 - front tires, in a set with rear tires 15.5R38;
- 11.2R24 – front tires, in a set with rear tires 11.2R42, 9.5-42;
Note – Tires 11.2R24 and 11.2R42 (9.5-42) are installed for tractor operation in beet
row spacing of 450 mm on a track of 1800 mm.
When using tires 15.5R38 and 11.2R42 at loads exceeding their carrying capacity, it
is necessary to use wheel doubling.
Tires 9.5-42 should only be used in twin version.
Consult your dealer for additional advice on dual wheel applications.
The parameters of tires used on the BELARUS-892/892.2 tractors are given in Table
3.9.1.
Table 3.9.1 – Tire sizes
Standard size Width of profile, mm Rollin
radius, mm
1)
360/70R24 357 —
13.6-20 345 —
11.2-20 284 —
11.2R24 284 —
16.9R38 429 800
18.4R34
F-11
467 770
15.5R38 394 750
11.2R42 284 749
9.5-42 241 730
_______________________________________________________________________________
1) This section contains only the rolling radii of the rear tires required for programming
the speed of the tachospeedometer, as indicated in subsection 3.14.3 "Procedure
for programming the tachospeedometer".
Rules for tire operation, selection of the optimal internal pressure in tires depending
on the operation conditions and load on tractor axles, as well as methods for setting the
track, are given in subsection 4.2 "Tractor use".
To Next Page
Loading...
