EasyManua.ls Logo

Belarus 892 - Fuses Located on the Body of the Oil Tank for HLL and HSC

Belarus 892
312 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
892-0000010B OM
57
Table 2.17.1 – Assignment of fuses in the dashboard
Number
in Figure 2.17.4
Rated
current
Name of protected circuit
1
15 А Stoplights, terminal (6) and terminal (8) of the trailer socket
2
15 А Road train sign lights (if any), rear service lights, cab ceiling light
3 15 А Warning light alarm
4
25 А Front and rear window wipers, front window washer
5 15 А Horn
6 25 А
High beam of road headlights, signal lamp of high beam of
headlights
7 25 А
Front service headlights on the roof, beacon, service headlights
on handgrips (when installed)
8 25 А
Powering of control circuit for fan-heater or powering of fan-
heater 80-8101720
9
25 А
Powering of loads operating with the starter and instrument
switch in the “instruments on” position: instruments, speed
sensors, power supply to fuses 15 and 16
10
25 А
Powering the fan-heater (when the fan-heater 80-8101720 is
installed, this fuse is not in use);
11 7,5
Marker lights of the left side, terminal (7) of the trailer
socket, license plate lighting
12 15А
Marker lights of the right side, terminal (5) of the trailer
socket, illumination of instruments
13 7,5 А Low beam of the left road headlight
14 7,5А Low beam of the right road headlight
15
7,5 А
Instruments, pilot lamp unit, speed sensors, warning sound alarm
(buzzer)
16
15А
Powering of turn flasher, powering of glow plug control system,
glow plug relay coil
2.17.4 Fuses located on the body of the oil tank for HLL and HSC
In addition to the fuses located in the dashboard and shown in Figure 2.17.2 and
Figure 2.17.4, there is also fuse 3 (Figure 2.17.5) in the on-board circuit of the "BELARUS-
892/892.2" tractors for the battery charging circuit and the general power supply to the on-
board circuit of the tractor before starting (rated 60A). Fuse 3 is located in fuse box 1. Fuse
box 1 is installed on bracket 2, attached to the left side of the body of the oil tank for HLL
and HSC.

Table of Contents

Related product manuals