892-0000010B OM
197
- replace oil filter of the engine;
- check and if required tighten the bolts attaching cylinder heads;
- check and if required adjust clearance between the valves and rockers arms;
- check lubrication in all assembly units according to clause 3 of Table 6.7.1. Where
required lubricate or replace the lubricant;
- check and if necessary restore hermiticity of the air cleaner and inlet line;
- check and, if necessary, adjust the tension of the fan belt;
- control engine running, steering, brakes, operation controls, lighting and warning
systems;
- check and adjust if necessary the tire pressure to a desired value in accordance
with Table 4.2.2;
4.5 Emergency actions
4.5.1 To stop the tractor immediately, sharply depress clutch and brake pedals.
4.5.2 For emergency stop of the engine pull the engine stop handle.
4.5.3. In case of an accident immediately stop the engine, engage tractor brakes, deactivate
accumulator batteries and get off the tractor through one of emergency exits, having opened
left or right cab door, depending on the tractor position, or rear screen, or the roof. If it is not
possible to open the emergency exits, break front or rear screen, or one of the lateral
screens with a heavy subject at hand and leave the tractor cab.
Note – Emergency exit allocation is given in subsection 2.18 “Cab locks and handles”.
4.5.4 In case the engine crankshaft speeds up excessively, kill the engine and brake the
tractor immediately.
4.5.5 In case a fire bed occurs, stop the engine, brake the tractor, turn off the accumulator
battery switch. Pour some sand onto the fire bed, cover with canvas cloth, sackcloth or other
dense texture. Use a carbon-dioxide fire extinguisher. Do not pour water over burning fuel
and oil.
To Next Page
Loading...
