892-0000010B OM
193
It is not admitted to inflate tires without pressure control.
Coupling the tractor with agricultural implements comply additionally with safety
measures concerning use of these implements.
Before coupling the tractor with agricultural implements make sure the automatic
grips of the lower and upper links of the RLL are clean and faultless. It is forbidden to operate
with the automatic grips out of order, their inner cavities stuffed with dirt and foreign particles.
If the tractor front part rises off the ground when heavy implements are hinged on the
mechanism of the rear lift linkage, mount front ballast weights.
Do not work under raised agricultural implements. Do not leave implements uplifted
when stopping for a long time.
Before lifting and lowering a hinged agricultural implement and also when turning the
tractor make sure there is no danger of catching somebody or stumbling on the hurdle.
The mounted and semi-mounted machine is to be lowered into its operating position
and up lifted into the hauling position only with a straight-line motion of the assembly unit.
To avoid breakdown of the tractor or the agricultural implement, drive and turn the
tractor assembly with the agricultural implement uplifted only after you make sure the rear
and side PTO are disengaged.
Linking and hinging the agricultural machines and implements on the tractor the rear
operator shall stay at a safety distance until the operation is fully stopped. The linkage
(hinge) shall be started only after the tractor operator gives a command.
Linking the machine cardan shaft to the RPTO, disengage the RPTO, stop the tractor
by means of the parking brake and stop the engine.
After disconnecting the machines driven by the PTO, remove cardan drives and cover
the PTO end extensions with protective caps.
Cardan shafts, transferring torque from the PTO of the tractor to the implement work-
ing units shall be safeguarded.
Operating with stationary machines, driven by the rear and side PTO, always engage
the parking brake and lock the rear wheels at the front and at the back. Make sure the
machine is securely fixed.
Make sure the safeguards of the rear and side PTO are mounted and, if the PTO is
not used, put back the cap of the PTO shaft end extension.
Do not wear loose clothes when working with the RPTO or near rotating equipment.
To avoid breakdown of the tractor or the agricultural machine, turning the tractor as-
sembly is possible only after the working units of the machine have been fully raised from
the ground.
When the tractor assemblies are operating in a column, they shall have an interval
not less than 30 m between each other.
Depending on operation conditions use natural ventilation of the cab or the unit of air
cooling and heating.
During tractor operation the operator shall use standard means of protection for hearing
organs.
In case the tractor assembly is operated or is driven in an area of power transmission
lines, a distance between the top of the tractor assembly and wires shall conform to Table
4.3.1.
Table 4.3.1
Line voltage, кV, up to
11 20-25 110 154-220 330-500
Horizontal distance, m, not less than
1,5 2 4 6 9
Vertical distance, m, not less than 1 2 3 4 6
To Next Page
Loading...
