Belarus 892 - Page 202

892-0000010B OM
202
3 Modification of length of both lifting rods, upper link for transport position of the
implement.
The modification is carried out in the following cases:
- to ensure the necessary road clearance;
- to ensure the sufficient safe clearance between the elements of the tractor and the
implement, excluding the contact of parts of the tractor implements (clearance is not less than
100 mm).
4. Modification of length of both buckles.
The modification is carried out in the following cases:
- during transportation of the implement, buckles shall be blocked for the limitation of
the implement rocking at run for the avoidance of the tractor elements damaging in case of
an incidence;
- during operation of mounted, semi-mounted tilling machines with passively operated
parts for the full processing (share and chisel ploughs, shallow ploughs, rippers and other
implements), free movement in horizontal plane (rocking) shall be ensured, and the buckles
shall be partial blocked.
IT IS FORBIDDEN TO OFFSET THE LONGITUDINAL AXIS OF THE IMPLEMENT,
CONCERNING THE LONGITUDINAL AXIS OF THE TRACTOR BY MEANS OF ADJUST-
MENT OF BUCKLES.
ATTENTION: THE LENGTH OF THE LEFT LIFTING ROD OF RLL WITH DRAFT
CONTROL UNIT MAKES 475 MM. THE LENGTH SHALL NOT BE CHANGED WITHOUT
PARTICULAR NEED. IT IS USUALLY THE RIGHT LIFTING ROD THAT IS LENGTH AD-
JUSTABLE. WHEN THE CROSSBAR IS USED ON THE SUSPENSION AXIS AND WHEN
REVERSIBLE PLOUGH IS USED THE LENGTH OF LIFTING RODS SHALL BE ALL THE
SAME!
ATTENTION: NONCOMPLIANCE WITH THE REQUIREMENTS FOR ADJUST-
MENT OF FASTENERS AND CROSSBARS MAY RESULT IN FASTENERS OR SUP-
PORT BRACKET BREAK OR OTHER BREAKAGE!
ATTENTION: ESSENTIAL FEATURES AND WAYS OF ADJUSTMENT OF PO-
SITION OF THE IMPLEMENT COUPLED WITH MOUNTED DEVICES ACCORDING TO
THE PECULIARITIES OF TECHNOLOGICAL PROCESS EXECUTION AND AGRO-
TECHNICAL REQUIREMENTS ARE SPECIFIED IN OPERATIONAL DOCUMENTATION
OF SUCH IMPLEMENTS. IF THERE IS NO INFORMATION IN OPERATIONAL DOC-
UMENTATION, YOU SHALL OBTAIN IT FROM THE MANUFACTURER OR SELLER OF
THE IMPLEMENT!