Belarus 892 - Page 205

892-0000010B OM
205
Table 5.4.1 – Characteristics of BELARUS-892/892.2 tractors hydraulic drive
Parameter description
Parameter
Value
(
characteristic
)
1 Paired hydraulic outputs (free)
Side Rea
r
Two pairs One pai
r
)
2 Oil pipe for free draining into tank (free drain
line)
- One optional
3 Total oil consumption through hydraulic out-
puts, l/min
Up to 46
1)
4 Rated minimum diameter of oil pipeline, mm:
- oil pressure pipeline
- oil drain pipeline
- free-drain
16,0
25,0
12,0
5 Hydraulic system working pressure, MPa
16,0
6 Pressure relief cracking pressure, MPa
20
-2
7 Allowable extraction of hydraulic fluid from a
tank, l, not more than
8,0
8 Allowable hydrostatic power take-off (GSPTO)
kW, not more than
12,0
9 Coupling thread of fast-coupling joint sleeves,
mm:
- oil pressure pipeline and oil drain pipeline
- free-drain oil pipeline
М201,5
М201,5
1)
A
t rated en
g
ine speed
ATTENTION: INSTALLATION OF ADDITIONAL COMPONENTS AND CHANGE OF
HYDRAULIC LIFT LINKAGE PIPELINES ROUTE IS ALLOWED ONLY AFTER CONSUL-
TATION WITH THE PLANT OR THE DEALER!
Note – Scheme of connection of hydraulic lift linkage outputs to an external consum-
ing system is presented in Figures 2.15.3 and 2.15.6.