Cisco 10000 Series User Manual

18-16
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 18 Regulating and Shaping Subscriber Traffic
Subscriber-Based IP Quality of Service
Verifying a Subscriber-Based IP QoS Configuration
To verify a subscriber-based IP QoS configuration, enter any of the following commands in privileged
EXEC mode:
Command Purpose
Router# show class-map
Displays all traffic class information.
Router# show class-map class-name
Displays the traffic class information for the user-specified traffic
class.
class-name is the name of the traffic class.
Router# show policy-map
Displays all configured service policies and associated traffic
classes.
Router# show policy-map policy-map-name
Displays the service policy information for the specified policy
map.
policy-map-name is the name of the policy map.
Router# show policy-map interface interface
Displays configuration information and statistics for the policies
attached to a specific interface.
interface interface is the type and number of the interface.
Router# show policy-map interface interface input
Displays configuration information and statistics for the input
policy attached to a specific interface.
interface interface is the type and number of the interface.
input indicates the inbound service policy.
Router# show policy-map interface interface
output
Displays configuration information and statistics for the output
policy attached to a specific interface.
interface interface is the type and number of the interface.
output indicates the outbound service policy.
Router# show policy-map [interface interface]
[input | output] [class class-name]
Displays configuration information and statistics for the class
you specify. This class is included in the policy map attached to
the interface you specify.
interface interface is the type and number of the interface.
input indicates the inbound service policy.
output indicates the outbound service policy.
class class-name is the name of the traffic class previously
configured in a class map.
Router# show caller
Displays information about callers on the PPP termination
aggregation (PTA) device or on the LNS.
Note The show caller command does not display information
about callers on the LAC.

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English