Cisco 10000 Series User Manual

17-30
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 17 Configuring Dynamic Subscriber Services
Applying QoS Parameters Dynamically to Sessions
Configuration Examples for Dynamic QoS Policies at the Session Level
This section provides the following configuration examples:
• Configuration Examples for Existing Service Policies and Pulled Policies, page 17-30
• Configuration Examples for Pulled Policies and a Router Without Existing Policies, page 17-32
Configuration Examples for Existing Service Policies and Pulled Policies
In Example 17-16 the policy maps named voice and outname are already configured on the router. The
sample output from the show policy-map command shows that the voice and outname policies are
attached to PVC 4/103 on ATM subinterface 4/0/0.3. The show policy-map interface command displays
statistical information about the policy maps.
Example 17-16 Displaying Existing Service Policies o the Router
Router# show policy-map
!
interface ATM4/0/0.3 multipoint
no atm enable-ilmi-trap
pvc 4/103
service-policy input voice
service-policy output outname
!
!
Router# show policy-map interface atm 4/0/0.3
ATM4/0/0.3: PVC 4/103 -
Service-policy input: voice
Class-map: class-default (match-any)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
0 packets, 0 bytes
5 minute rate 0 bps
Service-policy output: outname
Class-map: class-default (match-any)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
0 packets, 0 bytes
5 minute rate 0 bps

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English