Cisco 10000 Series User Manual

16-10
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 16 Fragmenting and Interleaving Real-Time and Nonreal-Time Packets
Link Fragmentation and Interleaving
ppp multilink group Command
To restrict a physical link to joining only a designated multilink group interface, use the ppp multilink
group command in interface configuration mode. To remove the restriction, use the no form of the
command. By default, this command is disabled.
ppp multilink group group-number
no ppp multilink group group-number
Syntax Description
ppp multilink group Command History
group-number Identifies the multilink group. This number must be identical to the
multilink-bundle-number you assigned to the multilink interface. Valid
values are:
• MLP over Serial-based LFI
– 1 to 9999 (Cisco IOS Release 12.2(28)SB and later releases)
– 1 to 9999 and 65,536 to 2,147,483,647 (Cisco IOS Release
12.2(31)SB2 and later releases)
• Single-VC MLP over ATM-based LFI
– 10,000 and higher
• Multi-VC MLP over ATM-based LFI
– 1 to 9999 (Cisco IOS Release 12.2(28)SB and later releases)
– 1 to 9999 and 65,536 to 2,147,483,647 (Cisco IOS Release
12.2(31)SB2 and later releases)
• MLP over Frame Relay-based LFI
– 10,000 and higher
Cisco IOS Release Description
Release 12.0 The ppp multilink group command was introduced on the PRE1 as
multilink-group command.
Release 12.2 The multilink-group command was changed on the PRE2 to ppp multilink
group. The multilink-group command was accepted by the command line
interpreter through Cisco IOS Release 12.2.
Release 12.2(28)SB This command was integrated in Cisco IOS Release 12.2(28)SB for the
PRE2.
Release 12.2(31)SB2 This command was introduced on the PRE3.

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English