1-44
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 1 Quality of Service Overview
QoS Features, Commands, and Changes
Weighting Feature
Cisco IOS Release: Release 12.3(7)XI1
Description: The VC weighting feature was introduced on the PRE2 to control the number of cells for
each VC that is sent into the virtual path (VP).
Cisco IOS Release: Release 12.2(28)SB
Description: This feature was integrated in Cisco IOS Release 12.2(28)SB.
Cisco IOS Release: Release 12.2(31)SB2
Description: This feature was introduced on the PRE3.
Policing Traffic
Documentation Reference: Chapter 6, “Policing Traffic”
• police Command (Single-Rate), page 1-44
• police percent Command, page 1-45
• police Command (Two-Rate), page 1-45
• show atm vp Command, page 1-46
• Percent-Based Policing Feature, page 1-46
• Policing Feature, page 1-46
• Single-Rate Color Marker Feature, page 1-47
• Two-Rate Three-Color Marker Feature, page 1-47
• ATM VP Average Traffic Rate, page 1-48
police Command (Single-Rate)
Cisco IOS Release: Release 12.0(17)SL
Description: The police command was introduced on the PRE1 to allow you to control the maximum
rate of traffic sent or received on an interface. This command included a single-rate two-color policer,
which allows you to classify traffic into two groups: traffic that conforms to the specified committed
information rate (CIR) and burst sizes, and traffic that exceeds either the CIR or the burst sizes.
Cisco IOS Release: Release 12.0(22)S
Description: This command was enhanced to include the set-mpls-exp-transmit policing action. This
action is available only on the PRE1.
Cisco IOS Release: Release 12.0(25)S
Description: This command was enhanced to include a three-color marker. A new violate-action
parameter allows you to specify the action to take for traffic that consistently violates the committed rate.
Cisco IOS Release: Release 12.2(16)BX
Description: This command was introduced on the PRE2 and included a single-rate two-color marker.