Cisco 10000 Series User Manual

15-12
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 15 Oversubscribing Physical and Virtual Links
Configuring Oversubscription
Oversubscribing Frame Relay PVCs Using Hierarchical Policies
For information about hierarchical policies, see Chapter 13, “Defining QoS for Multiple Policy Levels.”
To enable oversubscription of Frame Relay PVCs using hierarchical policies, enter the following
commands beginning in global configuration mode:
Command Purpose
Step 1
Router(config)# policy-map policy-map-name
Creates or modifies a child policy map. Enters policy-map
configuration mode.
policy-map-name is the name of the policy map. The name
can be a maximum of 40 alphanumeric characters.
Step 2
Router(config-pmap)# class class-map-name
Assigns the traffic class you specify to the policy map.
Enters policy-map class configuration mode.
class-map-name is the name of a previously configured
class map and is the traffic class for which you want to
define QoS actions.
Step 3
Router(config-pmap-c)# priority
(Optional) Assigns strict priority to the traffic class.
Note In Cisco IOS Release 12.0(25)S and
Release
12.3(7)XI, and later releases, the priority
command has no arguments. To specify a bandwidth
rate, use the police command. For more
information, see
Chapter 6, “Policing Traffic.”

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English