Cisco 10000 Series User Manual

1-31
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 1 Quality of Service Overview
QoS Features, Commands, and Changes
Link Fragmentation and Interleaving
Documentation Reference: Chapter 16, “Fragmenting and Interleaving Real-Time and Nonreal-Time
Packets”
• interface multilink Command, page 1-31
• multilink group Command, page 1-31
• ppp multilink Command, page 1-32
• ppp multilink fragment-delay Command, page 1-32
• ppp multilink fragmentation Command, page 1-33
• ppp multilink fragment disable Command, page 1-33
• ppp multilink group Command, page 1-33
• ppp multilink interleave Command, page 1-34
• MLP Over ATM-Based LFI Feature, page 1-34
• Multi-VC MLP Over ATM-Based LFI Feature, page 1-34
• MLP Over Frame Relay-Based LFI Feature, page 1-35
• Multi-VC MLP Over ATM-Based LFI Feature, page 1-34
• FRF.12 Fragmentation Feature, page 1-35
interface multilink Command
Cisco IOS Release: Release 12.0
Description: The interface multilink command was introduced on the PRE1 to create and configure a
MLP bundle.
Cisco IOS Release: Release 12.2(16)BX
Description: This command was introduced on the PRE2 and provides a multilink interface range of 1
to 9999.
Cisco IOS Release: Release 12.2(28)SB
Description: This command was integrated in Cisco IOS Release 12.2(28)SB.
Cisco IOS Release: Release 12.2(31)SB2
Description: This command was introduced on the PRE3 and the valid interface values for MLP over
serial and multi-VC MLP over ATM changed from 1 to 9999 (Release 12.2(28)SB) to from 1 to 9999
and 65,536 to 2,147,483,647.
multilink group Command
Cisco IOS Release: Release 12.0(23)SX
Description: The multilink group command was introduced on the PRE1 to assign a physical link to a
multilink group.

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English