Cisco 10000 Series

1-12
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 1 Quality of Service Overview
QoS Features, Commands, and Changes
• VLAN Tag-Based Quality of Service, page 1-60
Applying QoS Parameters Dynamically to Sessions
Documentation Reference: Chapter 18, “Regulating and Shaping Subscriber Traffic”
Cisco IOS Release: Release 12.3(7)XI2
Description: The Define Interface Policy-Map AV Pairs AAA feature was introduced on the PRE2 to
provide two RADIUS vendor-specific attributes (VSAs): cisco-avpair = “atm:vc-qos-policy-in=<in
policy name>” and cisco-avpair = “atm:vc-qos-policy-out=<out policy name>”. These VSAs allow you
to apply (pull) a policy map on an ATM virtual circuit (VC) during Point-to-Point Protocol over ATM
(PPPoA) or PPP over Ethernet over ATM (PPPoEoA) session establishment.
Cisco IOS Release: Release 12.2(28)SB
Description: This feature was integrated in Cisco IOS Release 12.2(28)SB and enhanced to provide
“push” functionality.
Applying Traffic Shaping Parameters Using RADIUS Profiles
Documentation Reference: Chapter 17, “Configuring Dynamic Subscriber Services”
• dbs enable Command, page 1-12
• default dbs enable Command, page 1-12
• Dynamic Bandwidth Selection Feature, page 1-13
dbs enable Command
Cisco IOS Release: Release 12.2(16)BX
Description: The dbs enable command was introduced on the PRE2 to enable dynamic bandwidth
selection.
Cisco IOS Release: Release 12.2(28)SB
Description: This command was integrated in Cisco IOS Release 12.2(28)SB.
default dbs enable Command
Cisco IOS Release: Release 12.2(16)BX
Description: The default dbs enable command was introduced on the PRE2 to remove the dbs enable
or no dbs enable command from an existing configuration.
Cisco IOS Release: Release 12.2(28)SB
Description: This command was integrated in Cisco IOS Release 12.2(28)SB.