17-14
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 17 Configuring Dynamic Subscriber Services
Applying Traffic Shaping Parameters Using RADIUS Profiles
Example 17-6 shows how to configure RADIUS attributes in a user profile for dynamic bandwidth
selection.
Example 17-6 Configuring a RADIUS User Profile for Dynamic Bandwidth Selection
user1@cisco.comPassword = “userpassword1”,Service-Type = Outbound
Service-Type= Outbound,
Cisco-Avpair= “vpdn:tunnel-id=shiva”,
Cisco-Avpair= “vpdn:tunnel-type=12tp”,
Cisco-Avpair= “vpdn:12tp-tunnel-password=password2”,
Cisco-Avpair= “vpdn:ip-addresses=172.16.0.0”,
Cisco-Avpair= “atm:peak-cell-rate=155000”,
Cisco-Avpair= “atm:sustainable-cell-rate=155000”
Configuration Examples for Dynamic Bandwidth Selection
This section provides additional configuration examples and includes the following:
• Configuration Example for Enabling Dynamic Bandwidth Selection on a VC Class and a PVC,
page 17-14
• Configuration Example for Enabling a RADIUS Domain Service Profile for Dynamic Bandwidth
Selection, page 17-16
• Configuration Example for Enabling a RADIUS User Profile for Dynamic Bandwidth Selection,
page 17-16
Configuration Example for Enabling Dynamic Bandwidth Selection on a VC Class and a PVC
Example 17-7 shows how to enable dynamic bandwidth selection on a VC class and a PVC.
Example 17-7 Enabling Dynamic Bandwidth Selection on a VC Class and a PVC
!
aaa new-model
!
!aaa authentication ppp default group radius
aaa authorization network default local
aaa session-id common
ip subnet-zero
ip ftp source-interface FastEthernet0/0/0
ip ftp username siv
ip ftp password dev1sit
ip host hardhead 10.10.0.4
ip host balloon 10.10.0.3
ip host seabass 10.10.0.2
!
vpdn enable
vpdn authen-before-forward
!
vpdn-group 2
request-dialin
protocol l2tp
domain cisco.com
initiate-to ip 192.168.1.2
local name c10k-lac
l2tp tunnel password 7 13061E010803
!
mpls ldp log-neighbor-changes
To Next Page
Loading...
Need help?
General
