13-30
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 13 Defining QoS for Multiple Policy Levels
Related Documentation
Class-map: class-default (match-any)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
0 packets, 0 bytes
5 minute rate 0 bps
Output queue: 0/64; 0/0 packets/bytes output, 0/0 drops
Router# show running-config interface atm 5/0/0.1
Building configuration...
Current configuration : 173 bytes
!
interface ATM5/0/0.1 point-to-point
ip address 1.1.1.2 255.255.255.0
pvc 0/100
vbr-nrt 3000 2000 10
encapsulation aal5snap
!
service-policy input Parentbps1
end
Router#
Related Documentation
This section provides hyperlinks to additional Cisco documentation for the features discussed in this
chapter. To display the documentation, click the document title or a section of the document highlighted
in blue. When appropriate, paths to applicable sections are listed below the documentation title.
Feature Related Documentation
Class maps Cisco IOS Quality of Service Solutions Configuration Guide,
Release 12.2
Part 8: Modular Quality of Service Command-Line Interface >
Configuring the Modular Quality of Service Command-Line
Interface > Modular QoS CLI Configuration Task List >
Creating a Traffic Class
Cisco IOS Quality of Service Solutions Command Reference,
Release 12.2
access-list rate-limit – fair-queue (WFQ) > class-map command
Oversubscription Cisco 10000 Series Router Quality of Service Configuration Guide
Oversubscribing Physical and Virtual Links
Policing Comparing Traffic Policing and Traffic Shaping for Bandwidth
Limiting tech note
Cisco IOS Quality of Service Solutions Configuration Guide,
Release 12.2
Configuring Traffic Policing
Cisco IOS Quality of Service Solutions Configuration Guide,
Release 12.2
Quality of Service Overview > Policing and Shaping
To Next Page
Loading...
Need help?
General
