Cisco 10000 Series User Manual

16-59
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 16 Fragmenting and Interleaving Real-Time and Nonreal-Time Packets
Configuration Examples for Link Fragmentation and Interleaving
Configuration Examples for Link Fragmentation and Interleaving
This section provides the following configuration examples:
• Configuration Example for MLP Over Serial-Based LFI, page 16-59
• Configuration Example for Single-VC MLP Over ATM-Based LFI, page 16-60
• Configuration Example for Multi-VC MLP Over ATM-Based LFI, page 16-61
• Configuration Examples for PVC-Based FRF.12 Fragmentation, page 16-63
• Configuration Example for Interface-Based FRF.12 Fragmentation, page 16-64
Configuration Example for MLP Over Serial-Based LFI
Example 16-15 shows a sample configuration for MLP over serial-based LFI. In the example, the MLP
bundle named Multilink 2 consists of three serial links: 8/0/0.2/7:0, 8/0/0.2/8:0, and 8/0/0.2/9:0.
Fragmentation and interleaving are both enabled on the bundle.
Example 16-15 Configuring MLP Over Serial-Based LFI
!
Router(config)# controller SONET 8/0/0
Router(config-controller)# framing SONET
Router(config-controller)# path 2 controller t3
!
Router(config)# controller T3 8/0/0.2
Router(config-controller)# overhead c2 4
Router(config-controller)# framing m23
Router(config-controller)# t1 7 channel-group 0 timeslots 1-24
Router(config-controller)# t1 8 channel-group 0 timeslots 1-24
Router(config-controller)# t1 9 channel-group 0 timeslots 1-24
!
Router(config)# class-map match-all prec_5
Router(config-cmap)# match ip precedence 5
!
Router(config)# policy-map policy_MLPLFI
Router(config-pmap)# class prec_5
Router(config-pmap-c)# priority
Router(config-pmap-c)# police 512000 9216 12000 conform-action transmit exceed-action
set-prec-transmit 3 violate-action drop
Router(config-pmap-c)# class class-default
Router(config-pmap-c)# bandwidth remaining percent 20
!
Router(config)# interface Multilink2
Router(config-if)# ip address 10.0.0.6 255.255.255.252
Router(config-if)# load-interval 30
Router(config-if)# ppp acfc local request
Router(config-if)# ppp acfc remote apply
Router(config-if)# ppp chap hostname group2
Router(config-if)# ppp multilink
Router(config-if)# ppp multilink fragment delay 2
Router(config-if)# ppp multilink interleave
Router(config-if)# ppp multilink group 2
Router(config-if)# service-policy output policy_MLPLFI
!
Router(config)# interface serial 8/0/0.2/7:0
Router(config-subif)# no ip address
Router(config-subif)# encapsulation ppp
Router(config-subif)# load-interval 30

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English