Cisco 10000 Series User Manual

8-7
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 8 Prioritizing Services
Configuring Multi-Level Priority Queues
Configuring Multi-Level Priority Queues
To configure Multi-Level Priority Queues (MPQ) in a policy map, enter the following commands
beginning in global configuration mode:
Command or Action Purpose
Step 1
policy-map policy-name
Creates or modifies a policy map. Enters policy-map
configuration mode.
policy-name is the name of the policy map.
Step 2
class class-name
Specifies a traffic class. Enters policy-map class
configuration mode.
class-name is the name of a previously configured traffic
class.
Step 3
priority level level
Assigns priority to a traffic class at the priority level
specified.
level level is the level of priority assigned to the priority
class. Valid values are 1 (high priority) and 2 (low priority).
Default: 1
Note Do not specify the same priority level for two
different classes in the same policy map.

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English