Cisco 10000 Series User Manual

2-5
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 2 Classifying Traffic
Traffic Classification Using Class Maps
Command Default
Per-match is the default mode.
qos match statistics Command History
Usage Guidelines for the qos match statistics Command
This command does not allow a no form of the command. The command operates in either per-match
mode or per-class mode. Specifying one mode automatically negates the current mode.
The Cisco 10000 series router with a PRE3 supports 262,144 unique class maps per system in per-match
mode and 4,194,304 unique class maps per system in per-class mode. Per-class mode provides greater
QoS scalability.
This command is not available on the PRE2. Due to memory limitations, the PRE2 supports a maximum
of 262,000 class maps per system.
When using the show commands in per-class mode, the per-match statistics display with a value of zero.
In per-class mode, the per-match statistics are zero in the MIB.
Defining Match Criteria Using the match Commands
To define the classification criteria for a class map, use the match commands in class-map configuration
mode. The match statements you define are the criteria the router uses to classify packets. To remove a
match statement, use the no form of this command. The router defaults to match-all.
Cisco IOS Release Description
Release 12.2(31)SB2 This command was introduced and implemented on the Cisco 10000 series
router for the PRE3.
Command Purpose
Router(config-cmap)# match access-group {number |
name}
Specifies that the packet must be permitted by the specified access
control list (ACL).
number identifies the ACL applied to an interface. Valid values are
from 1
to 2699.
name specifies that the packet must be permitted by the access list
whose name is name. The name can be a maximum of
40
alphanumeric characters.
Router(config-cmap)# match-all
Specifies that the packet must match all of the matching criteria
defined for a class map.
Router(config-cmap)# match-any
Specifies that the packet must match at least one of the matching
criteria defined for a class map.

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English