EasyManuals Logo

Cisco 10000 Series User Manual

Cisco 10000 Series
854 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #247 background imageLoading...
Page #247 background image
6-41
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 6 Policing Traffic
Verifying and Monitoring Traffic Policing
class c4
police 1000000 20000 30000 conform-action set-cos-transmit 4 exceed-action
set-cos-transmit 4 violate-action set-cos-transmit 4
class class-default
police 1000000 20000 30000 conform-action set-cos-transmit 5 exceed-action
set-cos-transmit 5 violate-action set-cos-transmit 5
On the PRE3, output from the show running-config command is the same as the above sample output,
except that the priority command configured in class c0 displays as priority level level-number.
On the PRE2 and PRE3, the show policy-map interface commands displays the set-cos-transmit action
and corresponding value when configured as a police action in a policy map.
Verifying and Monitoring Traffic Policing
The Cisco 10000 series router collects information about the number of conforming, exceeding, and
violating packets and bytes.
To verify and monitor traffic policing, enter any of the following commands in privileged EXEC mode:
Verification Examples for Traffic Policing
This section provides the following verification examples:
Verifying Policing for a Specific Traffic Class, page 6-42
Verifying Policing on a Specific Interface, page 6-42
Verifying Dual Police Actions—set-clp-transmit and set-mpls-exp-transmit, page 6-43
Command Purpose
Router# show policy-map
Displays statistical and configuration information about all of the
configured policy maps.
Router# show policy-map policy-map-name
Displays statistical and configuration information about the
policy map you specify.
Router# show policy-map interface interface
Displays statistical and configuration information about all of the
input and output policy maps attached to the interface you
specify.
For Cisco IOS Release 12.2(33)SB and later releases, if the
policy map attached to an interface has the police command
configured in it, the output from the show policy-map interface
command displays the police actions in a new line.

Table of Contents

Other manuals for Cisco 10000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 10000 Series and is the answer not in the manual?

Cisco 10000 Series Specifications

General IconGeneral
BrandCisco
Model10000 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals