Cisco 10000 Series User Manual

16-36
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 16 Fragmenting and Interleaving Real-Time and Nonreal-Time Packets
Multilink PPP-Based Link Fragmentation and Interleaving
Removing a Member Link from a MLP Bundle
To remove a member link from a MLP bundle, enter the following commands beginning in global
configuration mode:
Step 3
Router(config-if)# ppp multilink group
group-number
Moves this interface to the MLP bundle you specify.
group-number identifies the multilink group. Change this
group-number to the new MLP group group-number. Valid values
are:
• MLP over Serial-based LFI
– 1 to 9999 (Cisco IOS Release 12.2(28)SB and later
releases)
– 1 to 9999 and 65,536 to 2,147,483,647 (Cisco IOS
Release
12.2(31)SB2 and later releases)
• Single-VC MLP over ATM-based LFI
– 10,000 and higher
• Multi-VC MLP over ATM-based LFI
– 1 to 9999 (Cisco IOS Release 12.2(28)SB and later
releases)
– 1 to 9999 and 65,536 to 2,147,483,647 (Cisco IOS
Release
12.2(31)SB2 and later releases)
• MLP over Frame-Relay-based LFI
– 10,000 and higher
Command Purpose
Command Purpose
Step 1
Router(config)# interface type number
slot/module/port.channel:controller-number
Specifies the member link that you want to remove from the MLP
bundle. Enters interface configuration mode.
Step 2
Router(config-if)# no ppp multilink group
group-number
Removes the member link from the MLP group.
group-number identifies the multilink group.
Step 3
Router(config-if)# no ppp multilink
Disables Multilink PPP for the link.
Step 4
Router(config-if)# no ppp chap hostname
Removes PPP authentication.

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English