19-37
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 19 Configuring Quality of Service for PVC Bundles
Frame Relay PVC Selection
frame-relay vc-bundle Command History
Defaults
A bundle is not created.
Configuration Mode
Interface configuration
Usage Guidelines for the frame-relay vc-bundle Command
Use this command to create a unique Frame Relay PVC bundle if one has not already been created using
the frame-relay map command. Also, use this command to enter Frame Relay VC-bundle configuration
mode so you can configure PVC bundle attributes and PVC bundle members.
precedence Command (Frame Relay VC-bundle-member)
To configure the precedence levels for a Frame Relay permanent virtual circuit (PVC) bundle member,
use the precedence command in Frame Relay VC-bundle-member configuration mode. To remove the
precedence level configuration from the PVC, use the no form of the command.
precedence {level | other}
no precedence
Syntax Description
precedence Command History
Cisco IOS Release Description
Release 12.0(26)S This command was introduced on the PRE1.
level Specifies the precedence level or levels for this Frame Relay PVC bundle
member. Valid values are from 0 to 7.
You can configure a PVC bundle member with a single precedence level (0),
multiple individual precedence levels (0,2,3), a range of precedence levels
(0-2), multiple ranges of precedence levels (0-2,4-5), or a combination of
individual levels and level ranges (0,1,2-4,7).
Note This command is available when the PVC bundle match type is set
to precedence.
other Specifies that this Frame Relay PVC bundle member handles all of the
remaining precedence levels that are not explicitly configured on any other
bundle members.
Note Critical non-IP traffic automatically uses precedence level 0.
Cisco IOS Release Description
Release 12.0(26)S This command was introduced on the PRE1.
To Next Page
Loading...
Need help?
General
