18-17
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 18 Regulating and Shaping Subscriber Traffic
Subscriber-Based IP Quality of Service
Verification Examples for Subscriber-Based IP QoS Configurations
This section provides the following verification examples:
• Verification Example for the show policy-map interface Command, page 18-17
• Verification Example for the show caller Command, page 18-17
Verification Example for the show policy-map interface Command
Example 18-7 shows sample output from the show policy-map interface command. In the example, the
Gold policy map, attached to ATM interface 3/0/0, contains three traffic classes: Business,
Non-Business, and class-default.
Example 18-7 Displaying Service Policies Using the show policy-map interface Command
Router# show policy-map interface atm 3/0/0
ATM3/0/0
Service-policy output: Gold
Class-map: Business (match-all)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: ip precedence 4
Output queue: 0/128; 0/0 packets/bytes output, 0/0 drops
Bandwidth : 4999 kbps (Weight 3)
Class-map: Non-Business (match-all)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: ip precedence 3 5
Output queue: 0/64; 0/0 packets/bytes output, 0/0 drops
Bandwidth : 2001 kbps (Weight 1)
Class-map: class-default (match-any)
134 packets, 2760 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
Output queue: 0/4096; 3046242/75866271 packets/bytes output, 0/0 drops
Verification Example for the show caller Command
Example 18-8 shows sample output from the show caller command.
Example 18-8 Displaying Caller Information Using the show caller Command
Router# show caller
Line User Service Active Time Idle Time
con0 — TTY 00:14:31 00:12:14
vty2 — VTY 00:16:45 00:00:00
Vi1.1 abc@hello1 PPPoE 00:12:10 —
Vi1.2 abc@hello1 PPPoE 00:12:10 —
Vi1.3 abc@hello1 PPPoE 00:12:10 —
Vi1.4 abc@hello1 PPPoE 00:12:10 —
To Next Page
Loading...
Need help?
General
