Cisco 10000 Series User Manual

1-36
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 1 Quality of Service Overview
QoS Features, Commands, and Changes
Marking Traffic
Documentation Reference: Chapter 7, “Marking Traffic”
• set atm-clp Command, page 1-36
• set cos Command, page 1-36
• set discard-class Command, page 1-36
• set fr-de Command, page 1-37
• set ip dscp Command, page 1-37
• set ip precedence Command, page 1-37
• set mpls experimental Command, page 1-37
• set mpls experimental imposition Command, page 1-38
• set qos-group Command, page 1-38
• Marking Feature, page 1-38
set atm-clp Command
Cisco IOS Release: Release 12.0(17)SL
Description: The set atm-clp command was introduced on the PRE2 to set the cell loss priority (CLP)
bit to 1.
Cisco IOS Release: Release 12.2(28)SB
Description: This command was integrated in Cisco IOS Release 12.2(28)SB for the PRE2.
Cisco IOS Release: Release 12.2(33)SB
Description: This command was introduced on the PRE3 and PRE4.
set cos Command
Cisco IOS Release: Release 12.2(16)BX
Description: The set cos command was introduced on the PRE2 to set the Layer 2 class of service (CoS)
value of an outgoing packet. This command is available only on the PRE2.
Cisco IOS Release: Release 12.2(28)SB
Description: This command was integrated in Cisco IOS Release 12.2(28)SB.
set discard-class Command
Cisco IOS Release: Release 12.3(7)XI
Description: The set discard-class command was introduced on the PRE2 to mark a packet with a
discard-class value or to drop a specific traffic type during congestion. This command is available only
on the PRE2.

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English