2-9
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 2 Classifying Traffic
Traffic Classification Using Class Maps
match Commands History
Cisco IOS Release Command Description
Release 12.0(17)SL match The match command was introduced on
the PRE1.
match access-group This command was enhanced to include
matching on access lists.
match-all This command was enhanced to include
matching on all of the match criteria.
match-any This command was enhanced to include
matching on one match criterion.
match input-interface This command was enhanced to include
matching on the input interface.
match ip dscp This command was enhanced to include
matching on the IP DSCP value.
match ip precedence This command was enhanced to include
matching on the IP precedence value.
match ip rtp This command was enhanced to include
matching on the IP Real-Time Transport
Protocol (RTP).
match qos-group This command was enhanced to include
matching on a QoS group.
Release 12.0(17)SL match not This command was enhanced to include
matching on criteria that the packet does
not match.
Release 12.0(22)S match mpls experimental This command was enhanced to include
matching on the MPLS experimental
(EXP) bit value.
Release 12.2(15)BX match cos This command was introduced on the
PRE2 and enhanced to include matching
on the class of service for inbound policies
only.
Release 12.2(16)BX match mpls experimental
topmost
This command was enhanced to include
matching on the experimental (EXP) bit
value on the topmost label entry of the
packet.
Release 12.3(7)XI match discard-class This command was enhanced to include
matching on the discard-class value.
match mpls experimental
imposition
This command was enhanced to include
matching on the experimental (EXP) bit
value on the imposed label entry of the
packet.
Release 12.2(28)SB match This command was integrated in
Cisco
IOS Release 12.2(28)SB.
To Next Page
Loading...
Need help?
General
