Cisco 10000 Series User Manual

16-9
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 16 Fragmenting and Interleaving Real-Time and Nonreal-Time Packets
Link Fragmentation and Interleaving
ppp multilink fragment disable Command
To disable packet fragmentation, use the ppp multilink fragment disable command in interface
configuration mode. To enable fragmentation, use the no form of this command.
ppp multilink fragment disable
no ppp multilink fragment disable
ppp multilink fragment disable Command History
Usage Guidelines for the ppp multilink fragment disable Command
The ppp multilink fragment delay and ppp multilink interleave commands have precedence over the
ppp multilink fragment disable command. Therefore, the ppp multilink fragment disable command
has no effect if these commands are configured for a multilink interface and the following message
displays:
Warning: 'ppp multilink fragment disable' or 'ppp multilink fragment maximum' will be
ignored, since multilink interleaving or fragment delay has been configured and have
higher precedence.
To completely disable fragmentation, you must do the following:
Router(config-if)# no ppp multilink fragment delay
Router(config-if)# no ppp multilink interleave
Router(config-if)# ppp multilink fragment disable
Cisco IOS Release Description
Release 11.3 This command was introduced as ppp multilink fragmentation.
Release 12.2 The no ppp multilink fragmentation command was changed to
ppp
multilink fragment disable. The no ppp multilink fragmentation
command was recognized and accepted through Cisco IOS Release 12.2.
Release 12.2(28)SB This command was integrated in Cisco IOS Release 12.2(28)SB for the
PRE2.
Release 12.2(31)SB2 This command was introduced on the PRE3.

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English