18-2
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 18 Regulating and Shaping Subscriber Traffic
Subscriber-Based IP Quality of Service
• Queuing PPP Sessions on ATM VCs, page 18-29
–
Feature History for PPP Session Queuing on ATM VCs, page 18-30
–
Dynamically Applying QoS Policies to PPP Sessions on ATM VCs, page 18-30
–
PPP Session Queuing Inheritance, page 18-31
–
Interfaces Supporting PPP Session Queuing, page 18-31
–
Mixed Configurations and Queuing, page 18-31
–
Bandwidth Sharing and ATM Port Oversubscription, page 18-32
–
Oversubscription at the Session Level, page 18-32
–
Prerequisites for PPP Session Queuing on ATM VCs, page 18-32
–
Restrictions and Limitations for PPP Session Queuing on ATM VCs, page 18-32
–
Configuring PPP Session Queuing on ATM VCs, page 18-33
–
Configuration Examples for PPP Session Queuing on ATM VCs, page 18-39
–
Verifying PPP Session Queuing on ATM VCs, page 18-41
• Per-Session Shaping for ATM Interfaces, page 18-45
–
Feature History for Per-Session Shaping for ATM Interfaces, page 18-46
–
Restrictions and Limitations for Per-Session Shaping for ATM Interfaces, page 18-46
–
Configuring Per-Session Shaping for ATM Interfaces, page 18-46
–
Configuration Example for Per-Session Shaping on ATM Interfaces, page 18-50
–
Verifying Per-Session Shaping on ATM Interfaces, page 18-50
• Related Documentation, page 18-51
Subscriber-Based IP Quality of Service
The Cisco 10000 series router supports the following IP quality of service features for subscribers:
• Per Session Rate Limiting, page 18-3
• Per User Multiservice Rate Limiting, page 18-4
• Per Session Service Policy Using RADIUS, page 18-5
• Differential marking of the IP ToS bits (see the “IP Differentiated Services Code Point Marking”
section on page 7-6)
• Per User QoS Selection (see the “Applying Traffic Shaping Parameters Using RADIUS Profiles”
section on page 17-2 in Chapter 17, “Configuring Dynamic Subscriber Services.”)
To Next Page
Loading...
Need help?
General
