Cisco 10000 Series User Manual

17-26
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 17 Configuring Dynamic Subscriber Services
Applying QoS Parameters Dynamically to Sessions
Feature History for Define Interface Policy-Map AV Pairs AAA
Pulled Policy Maps
Pulled policy maps are QoS parameters that the router downloads from the RADIUS server to the ATM
VC. If a policy map is already configured on the ATM VC, the policy map pulled from the RADIUS
server has higher precedence. If you enter the show policy-map command, the output displays the policy
map pulled from the RADIUS server.
For example, the following sample output from the show policy-map interface command shows that
two service-policies (voice and outname) are attached to PVC 4/103.
Router# show policy-map interface atm 4/0/0.3
ATM4/0/0.3: PVC 4/103 -
Service-policy input: voice
Class-map: class-default (match-any)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
0 packets, 0 bytes
5 minute rate 0 bps
Service-policy output: outname
Class-map: class-default (match-any)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
0 packets, 0 bytes
5 minute rate 0 bps
When the router establishes a PPP over Ethernet over ATM (PPPoEoA) session, the router downloads or
pulls the policy maps set up on the RADIUS server to the VC. The following sample output from the
show policy-map interface command shows that the RADIUS policy maps (test_vc and dyn_out) are
now attached to PVC
4/103.
Router# show policy-map interface atm 4/0/0.3
ATM4/0/0.3: PVC 4/103 -
Service-policy input: test_vc
Class-map: class-default (match-any)
0 packets, 0 bytes
Cisco IOS Release Description Required PRE
Release 12.3(7)XI2 The Define Interface Policy-Map AV Pairs AAA feature was
introduced on the PRE2 and the “pull” functionality was
implemented. This feature provides two RADIUS
vendor-specific attributes (VSAs) that allow you to apply a
policy map on an ATM VC during PPP over ATM (PPPoA) or
PPP over Ethernet over ATM (PPPoEoA) session
establishment.
PRE2
Release 12.2(28)SB This feature was integrated in Cisco IOS Release 12.2(28)SB
and the “push” functionality was implemented.
PRE2

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English