6-43
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 6 Policing Traffic
Related Documentation
Verifying Dual Police Actions—set-clp-transmit and set-mpls-exp-transmit
The following shows sample output from the show policy-map command on the PRE3 and PRE4. In the
example, the class-default class is configured for dual police actions: set-clp-transmit and
set-mpls-exp-transmit.
Router# show policy-map clp
Policy Map clp
Class class-default
police 104000 100 10
conform-action set-clp-transmit
conform-action set-mpls-exp-transmit 1
exceed-action set-clp-transmit
exceed-action set-mpls-exp-transmit 2
violate-action set-clp-transmit
violate-action set-mpls-exp-transmit 3
Related Documentation
This section provides hyperlinks to additional Cisco documentation for the features discussed in this
chapter. To display the documentation, click the document title or a section of the document highlighted
in blue. When appropriate, paths to applicable sections are listed below the documentation title.
Feature Related Documentation
Control Plane Policing Control Plane Policing feature module, Release 12.2(31)SB2
DiffServ Cisco IOS Quality of Service Solutions Configuration Guide,
Release 12.3
Part 7: Quality of Service Solutions > Implementing DiffServ
for End-to-End Quality of Service Overview
Policing Comparing Traffic Policing and Traffic Shaping for Bandwidth
Limiting
Cisco IOS Quality of Service Solutions Configuration Guide,
Release 12.2
Quality of Service Overview > Policing and Shaping
Single-rate policer RFC 2697, A Single Rate Three Color Marker
Cisco IOS Quality of Service Solutions Configuration Guide,
Release 12.2
Part 4: Policing and Shaping > Policing and Shaping Overview
Three-color marker for traffic policing (single-rate) Release Notes for the Cisco 10000 Series ESR for Cisco IOS
Release 12.0(23)SX
New Features in Cisco IOS Release 12.0(23)SX > Single-Rate
3-Color Marker for Traffic Policing
RFC 2697, A Single Rate Three Color Marker
To Next Page
Loading...
Need help?
General
