17-16
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 17 Configuring Dynamic Subscriber Services
Applying Traffic Shaping Parameters Using RADIUS Profiles
!
!
interface ATM8/0/0.3 point-to-point
atm pppatm passive
range pvc 33/333 33/344
class-range pppoaRange
!
!
interface Virtual-Template1
ip address negotiated
peer default ip address pool pppoa-pool
ppp authentication pap callin
ppp direction callin
!
ip default-gateway 24.1.0.4
ip classless
ip route 10.10.0.0 255.255.0.0 10.14.0.200
no ip http server
ip pim bidir-enable
!
!
radius-server host 10.14.0.210 auth-port 1645 acct-port 1646
radius-server key cisco
radius-server authorization permit missing Service-Type
!
Configuration Example for Enabling a RADIUS Domain Service Profile for Dynamic Bandwidth
Selection
Example 17-8 shows how to enable a RADIUS domain service profile for dynamic bandwidth selection.
Example 17-8 Enabling a RADIUS Domain Service Profile for Dynamic Bandwidth Selection
cisco.com Password = “cisco”, Service-Type = Outbound
cisco-avpair = “vpdn:tunnel-id=shiva”,
cisco-avpair = “vpdn:tunnel-type=l2tp”,
cisco-avpair = “vpdn:l2tp-tunnel-password=password2”,
cisco-avpair = “vpdn:ip-addresses=172.16.1.1”,
cisco-avpair = “atm:peak-cell-rate=155000”,
cisco-avpair = “atm:sustainable-cell-rate=155000”
Configuration Example for Enabling a RADIUS User Profile for Dynamic Bandwidth Selection
Example 17-9 shows how to enable a RADIUS user profile for dynamic bandwidth selection.
Example 17-9 Enabling a RADIUS User Profile for Dynamic Bandwidth Selection
L2TP
user1@cisco.com Password = “cisco”, Service-Type = Outbound
cisco-avpair = “vpdn:tunnel-id=shiva”,
cisco-avpair = “vpdn:tunnel-type=l2tp”,
cisco-avpair = “vpdn:l2tp-tunnel-password=password2”,
cisco-avpair = “vpdn:ip-addresses=172.16.1.1”,
cisco-avpair = “atm:peak-cell-rate=155000”,
cisco-avpair = “atm:sustainable-cell-rate=155000”
To Next Page
Loading...
Need help?
General
