Cisco 10000 Series User Manual

19-34
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 19 Configuring Quality of Service for PVC Bundles
Frame Relay PVC Selection
If you configure a PVC with the bump explicit command, you can specify the service level to which
traffic is bumped when that PVC goes down, and the traffic is directed to a PVC mapped with that level.
If the PVC that picks up and carries the traffic goes down, the traffic is subject to the bumping rules for
that PVC. You can specify only one service level for bumping.
The PVC accepts bumped traffic by default. If the PVC has been previously configured to reject bumped
traffic, you must use the bump traffic command to return the PVC to its default condition.
To configure a discrete PVC to reject bumped traffic when the traffic is directed to it, use the no bump
traffic command.
Note When no alternative PVC can be found to handle bumped traffic, even when there are no packets of that
traffic type present, the bundle is declared down. In the case where default (implicit) bumping is used
for all PVCs, the PVC that is handling the lowest service level can be configured to bump explicitly to
a PVC handling a higher service level.
dscp Command (Frame Relay VC-bundle-member)
To configure the differentiated services code point (DSCP) levels for a Frame Relay permanent virtual
circuit (PVC) bundle member, use the dscp command in Frame Relay VC-bundle-member configuration
mode. To remove the DSCP level configuration from the PVC, use the no form of the command.
dscp {level | other}
no dscp level
Syntax Description
dscp Command History
Defaults
DSCP levels are not configured.
level Specifies the DSCP level or levels for this Frame Relay PVC bundle
member. Valid values are from 0 to 63.
You can configure a PVC bundle member with a single DSCP level (9),
multiple individual DSCP levels (25,35,45), a range of DSCP levels
(25-35), multiple ranges of DSCP levels (25-35,45-55), or a combination of
individual levels and level ranges (10,20,25-35,40,45-55,60).
Note This command is available when the PVC bundle match type is set
to dscp. By default, the PVC members are configured to reject
bumping when the match-type is dscp.
other Specifies that this Frame Relay PVC bundle member handles all of the
remaining DSCP levels that are not explicitly configured on any other
bundle members.
Cisco IOS Release Description
Release 12.0(26)S This command was introduced on the PRE1.

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English