Cisco 10000 Series User Manual

1-37
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 1 Quality of Service Overview
QoS Features, Commands, and Changes
Cisco IOS Release: Release 12.2(28)SB
Description: This command was integrated in Cisco IOS Release 12.2(28)SB.
set fr-de Command
Cisco IOS Release: Release 12.2(31)SB2
Description: The set fr-de command was introduced on the PRE2 and PRE3 to mark a Frame Relay
packet’s discard eligibility (DE) bit.
Cisco IOS Release: Release 12.2(33)SB
Description: This command was introduced on the PRE4.
set ip dscp Command
Cisco IOS Release: Release 12.0(17)SL
Description: The set ip dscp command was introduced on the PRE1 to mark a packet by setting the
differentiated services code point (DSCP) value in the type of service (ToS) byte.
Cisco IOS Release: Release 12.2(28)SB
Description: This command was integrated in Cisco IOS Release 12.2(28)SB.
Cisco IOS Release: Release 12.2(31)SB2
Description: This command was introduced on the PRE3 to allow you to mark the IP DSCP bits of
traffic on the L2TP access concentrator (LAC).
set ip precedence Command
Cisco IOS Release: Release 12.0(17)SL
Description: The set ip precedence command was introduced on the PRE1 to set the precedence value
in a packet header.
Cisco IOS Release: Release 12.2(28)SB
Description: This command was integrated in Cisco IOS Release 12.2(28)SB.
set mpls experimental Command
Cisco IOS Release: Release 12.0(22)S
Description: The set mpls experimental command was introduced on the PRE1 to set the value of the
Multiprotocol Label Switching (MPLS) experimental (EXP) field. This command is available only on
the PRE1.
Cisco IOS Release: Release 12.2(28)SB
Description: This command was integrated in Cisco IOS Release 12.2(28)SB.

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English