EasyManua.ls Logo

Cisco SGE2000 - Cisco - Gigabit Switch - Page 111

Cisco SGE2000 - Cisco - Gigabit Switch
410 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring Device Security
Defining Access Control
Cisco Small Business SFE/SGE Managed Switches Administration Guide 102
4
-
IPV6:ICMP
— Matches packets to the Matches packets to the IPv6 and
I
nternet Control Message Protocol
.
-
EIGRP
Enhanced Interior Gateway Routing Protocol
(EIGRP). Provides
fast convergence, support for variable-length subnet mask, and
supports multiple network layer protocols.
-
OSPF
— The
Open Shortest Path First
(OSPF) protocol is a link-state,
hierarchical Interior Gateway Protocol (IGP) for network routing Layer
Two (2) Tunneling Protocol, an extension to the PPP protocol that
enables ISPs to operate Virtual Private Networks (VPNs).
-
IPIP
IP over IP
(IPIP). Encapsulates IP packets to create tunnels
between two routers. This ensure that IPIP tunnel appears as a single
interface, rather than several separate interfaces. IPIP enables tunnel
intranets occur the internet, and provides an alternative to source
routing.
-
PIM
— Matches the packet to
Protocol Independent Multicast
(PIM).
-
L2TP
— Matches the packet to
Layer 2 Internet Protocol
(L2IP).
-
ISIS
Intermediate System - Intermediate System
(ISIS). Distributes IP
routing information throughout a single Autonomous System in IP
networks.
-
ANY
— Matches the protocol to any protocol.
Source Port — Defines the TCP/UDP source port to which the ACE is matched.
This field is active only if 800/6-TCP or 800/17-UDP are selected in the Select
from List drop-down menu. The possible field range is 0 - 65535.
Dest. Port Defines the TCP/UDP destination port. This field is active only if
800/6-TCP or 800/17-UDP are selected in the Select from List drop-down
menu. The possible field range is 0 - 65535.
Flag Set — Sets the indicated TCP flag that can be triggered.
ICMP Type — Filters packets by ICMP message type. The field values is 0-255.
ICMP Code — Indicates and ICMP message code for filtering ICMP packets.
ICMP packets that are filtered by ICMP message type can also be filtered by
the ICMP message code.
IGMP Typ e — Filters packets by IGMP message or message types.
Source

Table of Contents

Other manuals for Cisco SGE2000 - Cisco - Gigabit Switch

Related product manuals