Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Configuring System Time
Defining SNTP Authentication
Cisco Small Business SFE/SGE Managed Switches Administration Guide 39
3
• Encryption Key ID — Select if Key Identification is used to communicate
between the SNTP server and device. The range is 1 - 4294967295.
STEP 3 Define the relevant fields.
STEP 4 Click Add. The SNTP Server is added, and the device is updated.
Defining SNTP Authentication
The SNTP Authentication Page provides parameters for performing authentication
of the SNTP server.
STEP 1 Click System > System Management > Time > SNTP Authentication. The SNTP
Authentication Page
opens:
SNTP Authentication Page
The
SNTP Authentication Page contains the following fields:
• Enable SNTP Authentication — Indicates if authenticating an SNTP session
between the device and an SNTP server is enabled on the device. The
possible field values are:

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x