Cisco SGE2000 - Cisco - Gigabit Switch - Mapping DNS Hosts

Configuring IP Information
Domain Name System
Cisco Small Business SFE/SGE Managed Switches Administration Guide 226
7
• IPv6 Address Type — Indicates the IPv6 Type. The possible field values are:
- Link-Local — Indicates the IPv6 address is link-local.
- Global Unicast — Indicates the IPv6 address is global Unicast.
• Link Local Interface —Indicates the IPv6 link-local interface. The possible field
values are:
- VLAN — Indicates that theIPv6 link-local interface is defined as a VLAN
used.
- ISATAP — Indicates that the IPv6 link-local interface is defined as a
virtual IPv6 local link via ISATAP.
• DNS Server IP Address— Enter the DNS server’s IP address.
• Set DNS Server Active — Defines active status of the new DNS Server. The
possible values are:
- Checked — This new server becomes the active DNS Server.
- Unchecked — This new server is not the active DNS Server.
STEP 3 Define the relevant fields.
STEP 4 Click Apply. The DNS server is added, and the device is updated.
Mapping DNS Hosts
The Host Mapping Page provides information for defining DNS Host Mapping.
To add a host map: