Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Managing System Logs
Viewing Remote Logs
Cisco Small Business SFE/SGE Managed Switches Administration Guide 355
16
Viewing Remote Logs
The Remote Log Servers Page contains information for viewing and configuring
the Remote Log Servers. New log servers and the minimum severity level of
events sent to them may be added.
STEP 1 Click Admin > Logs > Remote Log Servers. The Remote Log Servers Page opens:
Remote Log Servers Page
The
Remote Log Servers Page contains the following fields:
• Server — Specifies the server IP address to which logs can be sent.
• UDP Port — Defines the UDP port to which the server logs are sent. The
possible range is 1 to 65535. The default value is 514.
• Facility — Defines a user-defined application from which system logs are sent
to the remote server. Only one facility can be assigned to a single server. If a
second facility level is assigned, the first facility is overridden. All applications
defined for a device utilize the same facility on a server. The field default is
Local 7. The possible field values are Local 0 - Local 7.
• Description — Provides a user-defined server description.
• Minimum Severity — Indicates the minimum severity level for logs that are sent
to the server. For example, if Notice is selected, all logs from a Notice severity
and higher are sent to the remote server.

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x